ML150 G3 - Dual Processor

[Justin Medcraft]

OK, if you've not already noticed, i've already put a thread on here with my initial problem with the SATA RAID controller issue I experienced before. This has now been resolved and I am eternally grateful. I have installed SBS2003 sucessfully. After re-booting I have logged on, only to find that I have two problems that I need to resolve before I finish the configuration of SBS2003. The first is that I need to manually configure IP addresses to the NICs. That's not a problem at all. I already have my plan so I shall go onto my next problem. I am being told that I need to install drivers for my 2nd processor. I looked in my Device Manager to find an unknown PCI device (not 100% sure as i'm typing this from home). Once I get all of the proper information I shall let you know. Initially though could anybody please give me any advice? Are these drivers available on the internet if I were to connect? I look forward to a reply from somebody in the very near future.

Justin Medcraft

[KarloChacon]

hi

ml150 g3 - w2003

try this drivers

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=1163831&prodNameId=3279687&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-ff1166e97dfa40d7bd2871b059

and this
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=1163831&prodNameId=3279687&swEnvOID=1005&swLang=8&mode=2&taskId=135&swItem=MTX-f2a46bd545614cea9bb1d74678


from here

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodNameId=3279687&prodTypeId=15351&prodSeriesId=1163831&swLang=8&taskId=135&swEnvOID=1005#11394

regards