ML150 and windows2003

[EnricoS_1]

Hi all!

How can I make a clean install of windows2003 on a ML150 Proliant server?

Many thanks

Enrico

[ramesh_naik_]

Hi Enrico,

Few questions here:
1. What is the generation of the server?
2. What is the controller that is being used?
3. Is it a SATA or a SCSI model server?

This link might help you installing the OS on a SATA model:
http://forums1.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=969559

Regards,
rmn

[hObbeS_1]

Hi there,

I'm having the same problem. My server is a ProLiant ML150 G3 series. I'm trying to install a Windows 2003 server but it doesn't seems to detect the hard disk even after i load the LSI driver from the F6 option. Your advice is much important tp me. thank you

[ramesh_naik_]

HObbes,

You may want to refer this for the ML150 G3 installation:

http://forums1.itrc.hp.com/service/forums/questionanswer.do?threadId=1070140

Hope this works!!!!

Regards,
rmn

[hObbeS_1]

Hello Ramesh,

Thanks for that feedback, i've seen that topic but it doesn't work for my case. But i already can proceed for the installation. I did a format on the hard drive with the LSI Ultility and try again and it works. Weird but it works, heh. But neway thanks alot for, appreciated it.



Good day,
hObbeS

[Enrico1S]

Hi ramesh_naik_!

I have a ml150 G2 server and I use the scsi controller. I tried the driver on the hp site, but in this way I can only install Windows2003 again and I cannot format the SCSI disk. There is a SmartstartCD that works with my system (the 7.60 do not support it)?

Thanks for the answer!

Enrico