ML30 Gen10 with Raidctrl S100i and Installation CentOS 7.x 1810

[werner.zeller]

Hi, I have a ML30 with the S100i arraycontroller with 2 Disks (1TB) for Raid1. I did create the Raid1 with the Array Controller software in the provisioning menu. After booting with of CentOS7x from USB, under Device Selection I can see both Disks, not the logical Lun.  What I need is Raid1 Hardware or Software based...

How can I do this?

Thnaks

Best regards

werner

[Jimmy Vance]

---

@werner.zeller wrote:

Hi, I have a ML30 with the S100i arraycontroller with 2 Disks (1TB) for Raid1. I did create the Raid1 with the Array Controller software in the provisioning menu. After booting with of CentOS7x from USB, under Device Selection I can see both Disks, not the logical Lun.  What I need is Raid1 Hardware or Software based...

How can I do this?

Thnaks

Best regards

werner

---

The S100i Dynamic Smart Array is a software based RAID controller.  The software RAID function is only supported in Windows. For hardware based RAID you will need to install either the HPE Smart Array P408i-p SR Gen10 or the HPE Smart Array E208i-p SR Gen10 PCIe controller