ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML310 Memory Configuration for Interleaving

SOLVED
Go to solution
Jim McNelis_1
Occasional Visitor

ML310 Memory Configuration for Interleaving

If currently 2x512 in slots 1 and 2
and I want to add 2x1024 in slots 3 and 4,
will this configuration support interleaving?

And, would it be better to put the new 2x1024 in slots 1 and 2, and the old 2x512 in slots 3 and 4 or does it not matter?

Thanks.
5 REPLIES
Vijay_44
Honored Contributor

Re: ML310 Memory Configuration for Interleaving

Hi,

The ML310 does not support interleaving. The recommended population order is slot 1,2,3 and then 4.
There’s your problem!!! This thing is set to EVIL!
SAKET_5
Honored Contributor

Re: ML310 Memory Configuration for Interleaving

Hi Jim,

just make sure that the DIMMS have been populated in sequence otherwise next boot will show up a sequence error for the memory.

ML310 wont support interleaving...

hope it helps and dont forget to assign points:)

regards,
Jim McNelis_1
Occasional Visitor

Re: ML310 Memory Configuration for Interleaving

OK Thanks... on the sequencing: Can't I just put both 1024 DIMMS in slots 3 and 4 then boot?
Vijay_44
Honored Contributor
Solution

Re: ML310 Memory Configuration for Interleaving

you could...as long as 1 and 2 are also populated
There’s your problem!!! This thing is set to EVIL!
Jim McNelis_1
Occasional Visitor

Re: ML310 Memory Configuration for Interleaving

thanks