HPE Community
ProLiant Servers (ML,DL,SL)
1751783 Members
5018 Online
108781 Solutions
New Discussion

Re: ML330 G2 cannot find SCSI disks

 
Andy Coster
Occasional Advisor

‎03-20-2003 07:28 AM

‎03-20-2003 07:28 AM

Re: ML330 G2 cannot find SCSI disks

Yes, the controller is the primary boot device, and in fact, I have disabled the onboard SCSI just to be sure....

AC
0 Kudos
Reply
Jarmo_1
New Member

‎04-05-2003 09:59 PM

‎04-05-2003 09:59 PM

Re: ML330 G2 cannot find SCSI disks

Hi Andy!
Try this: press F6 when the message "Setup is now inspecting your hardware configuration" appears(just when boot starts). NOTE: You dont have much time to press F6! And then follow instructions. Its allmost same when adding driver after selecting repair.
That helped me with Proliant DL380 G2.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.