ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML330 G3 Error that won;t die

Doug Peters_3
Occasional Contributor

ML330 G3 Error that won;t die

I have a ML330 that is givng the following error message and we have replaced the memeory and the system board and it will not go away. Of course it's out of warrenty and I getting heat about spending money and not getting it fixed.

Corrected Memory Error threshold exceeded (System Memory, Memory Module 1)
1 REPLY
NMory
Respected Contributor

Re: ML330 G3 Error that won;t die

That error 90% of time is fixed by replacing the affected memory module. It's imperative that you use Compaq memory modules only, third party memory modules might cause those type of errors.

Memory Configuration for ML330 G3

Memory Standards: DIMMs must be industry-standard, ECC Registered PC2100 DDR SDRAM DIMMs and support CAS Latency 2.5 (CL=2.5).

Memory Installation: It's recommended that the DIMMs be installed sequentially in slots 1, 2, 3, and then 4.

Standard Memory

256 MB (expandable to 4 GB) of non interleaved PC2100 DDR SDRAM running at 266 MHz, with Advanced ECC capabilities (1 x 256 MB)

Standard Memory Plus Optional Memory

Up to 3328 MB memory is available with the optional installation of PC2100 DDR SDRAM memory kits.

Standard Memory Replaced with Optional Memory

Up to 4096 MB memory is available with the removal of the standard 256 MB of memory and the optional installation of PC2100 DDR SDRAM DIMM memory kits.

Check these Customer Advisories that might help you in someway:

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=PSD_CN0416W

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=PSD_EA030630_CW01

Regards,

LN