ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ML350 G1 and SmartArray431 - hang during config array

 
Marcin Piaszczynski
Occasional Contributor

ML350 G1 and SmartArray431 - hang during config array

I have
ML350 800MHz
4x18GB SCSI3 SCA hotpluged drives
SmartArray431

All bios are upgraded to last versions.
When I try to configure arrays (2 mirrors) via SmartStart5.50 (or 4.50 or 4.90) software hangs during saving configuration to SmartArray (in auto and manual mode).
When I configure arrays from F8 key at startup and after that run SmartStart then software hangs during detecting array controlers...
My question is, what I do wrong ??

2 REPLIES
Jaime Bolanos Rojas.
Honored Contributor

Re: ML350 G1 and SmartArray431 - hang during config array

Marcin, software wise you did everything possible so far, it's time to start looking at a hardware problem on the array controler.
Reseat the array controller if is not embedded, reaseast cables for the i/o system.

Check again, if that does not work, i would start looking at the replacement part.

Regards,

Jaime.
Work hard when the need comes out.
Oleg Koroz
Honored Contributor

Re: ML350 G1 and SmartArray431 - hang during config array

Can you successfully run ADU?
Firmware for 431?