HPE Community
ProLiant Servers (ML,DL,SL)
1753417 Members
5082 Online
108793 Solutions
New Discussion юеВ

ML350 G4p how to install OS

 
Shurumbura
New Member

тАО08-01-2010 01:05 AM

тАО08-01-2010 01:05 AM

ML350 G4p how to install OS

New server ML350 with 6 disks display messages "Not BIOS installed" and "No logical drives found". After that it reboot again.
0 Kudos
Reply
2 REPLIES 2
Jan Soska
Honored Contributor

тАО08-01-2010 11:19 PM

тАО08-01-2010 11:19 PM

Re: ML350 G4p how to install OS

Hello, it looks there is no storage boot bios enabled. Check your SmartArray controler setup and enable it.

Jan
0 Kudos
Reply
Trygve Henriksen
Respected Contributor

тАО08-01-2010 11:37 PM

тАО08-01-2010 11:37 PM

Re: ML350 G4p how to install OS

If there's no logical drives defined on the disk set, the controller won't load the BIOS.
(And you get the 'No BIOS installed' message)

Soon after it starts the detection phase on the drives you'll see a message to press [F8].
Do so to enter the Controller setup where you can define an array.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.