ML350G1 cannot clear IML

[Dan Sanford]

Hi:
I have a ML350G1 with 256MB RAM which i cannot clear the IML on. If I try to run the IML Viewer it hourglasses for about 2 minutes then returns a "out of memory" error. If I try to clear it from the management page it says it is going to clear it but then after refreshing it hasn't.
Any ideas would be appreciated,

Dan

[Tarek Kawach]

hi dan:


here is advisory on this issue

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=PSD_EM030516_CW01

you can also run system erase on the server
- or clear nvram.

- the IMLV is coming from the system health drivers ; possible need to update them and or reinstall.

Tarek.

[Dan Sanford]

Thanks for the advice and the link, I had viewed that one already though. I forgot to mention that i am running the latest Support Pack v7.10a which includes a newer System Management driver than that article suggests. Also, this is a remote server about 6 hours from me so i can't reboot it and wipe the NVRAM.

Any additional suggestions would be appreciated,

Dan

[clausw]

if you want to clear the IML remotely an you do this through the managementagents, please check your SNMP Config.
You must enable SNMP Set's and configure 127.0.0.1 as trap destination.