HPE Community
ProLiant Servers (ML,DL,SL)
1752608 Members
4698 Online
108788 Solutions
New Discussion юеВ

Re: ML370 G3 (NETWARE)

 
Doug Roehm
Occasional Contributor

тАО08-08-2004 01:39 AM

тАО08-08-2004 01:39 AM

ML370 G3 (NETWARE)

Currently running server at 100MB Full Duplex. Just installed a GIG switch the server will connect to.. What is the best way to change the server to GIG connection.. (So I simply add/delete items in the inetcfg ??

Thanks in advance
0 Kudos
Reply
3 REPLIES 3
Symen
Frequent Advisor

тАО08-09-2004 10:43 PM

тАО08-09-2004 10:43 PM

Re: ML370 G3 (NETWARE)

Just make the driver (Q57) load with speed 1000FD. Please note that 1000 Half duplex is not possible
0 Kudos
Reply
Doug Roehm
Occasional Contributor

тАО08-09-2004 10:57 PM

тАО08-09-2004 10:57 PM

Re: ML370 G3 (NETWARE)

OK, but what about the G2 Servers that use the N100 versus the N1000 driver.. To change that, what is the best way??

Thanks again
0 Kudos
Reply
Symen
Frequent Advisor

тАО08-09-2004 11:24 PM

тАО08-09-2004 11:24 PM

Re: ML370 G3 (NETWARE)

Oh you mean you want to keep running at 100 megabits?
Then you'll have to configure your switch to do so on that port. maybe configure your switch to auto-negotiate that port and configure your server to 100FD
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.