- Community Home
- >
- Servers and Operating Systems
- >
- ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- ML370 and PowerQuest
ProLiant Servers (ML,DL,SL)
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
-
- Categories
- Blogs
-
Quick Links
- Community
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Contact
- Email us
- Tell us what you think
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Enterprise.nxt
- Marketplace
- Aruba Airheads Community
-
Forums
-
Blogs
-
InformationEnglish
ML370 and PowerQuest
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
04-02-2003 12:02 PM
04-02-2003 12:02 PM
ML370 and PowerQuest
ML370 and PowerQuest
I'm using a DOS boot disk (made with Power Deploy Disk Builder) to connect to the network for creating a PowerQuest image.
Under normal conditions, it takes 8 seconds to launch PowerQuest. I can do it without any problem with every server, but with the ML370 I have problems. It takes 8 seconds to run. but for the ML370s it takes almost 3 minutes and after that, it doesn't show the volumes on the remote server where the images are
I have replaced the NIC, added more memory, changed the controller on the client machine; even I have created a small network and there everything works.
Images reside on a Windows 2000 with Active Directory and a 5300 SCSI controller with 2 18Gb and 4 72Gb with an 8 36 Gb StorageWorks. Does anyone know where the problem could be? Netbios?
Under normal conditions, it takes 8 seconds to launch PowerQuest. I can do it without any problem with every server, but with the ML370 I have problems. It takes 8 seconds to run. but for the ML370s it takes almost 3 minutes and after that, it doesn't show the volumes on the remote server where the images are
I have replaced the NIC, added more memory, changed the controller on the client machine; even I have created a small network and there everything works.
Images reside on a Windows 2000 with Active Directory and a 5300 SCSI controller with 2 18Gb and 4 72Gb with an 8 36 Gb StorageWorks. Does anyone know where the problem could be? Netbios?
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content
United States
Hewlett Packard Enterprise International
Communities
- Communities
- HPE Blogs and Forum
© Copyright 2018 Hewlett Packard Enterprise Development LP