- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Moving MSA30 to another controller
ProLiant Servers (ML,DL,SL)
1752852
Members
3620
Online
108790
Solutions
Forums
Categories
Company
Local Language
юдл
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
юдл
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-21-2006 04:30 PM
тАО08-21-2006 04:30 PM
Moving MSA30 to another controller
I have DL380 G4 Storage Server with SmartArray 6i integrated controller. An MSA30 with two arrays RAID 5 is attached to this server. Once server was stopped for replace of motherboard. For that time I decided to move MSA30 to another server (DL360 G4) with SmartArray 6404 controller. I made all steps from manual for that controller. But no arrays was appeared at server, it detected only drives without any configuration. But when motherboard on DL380 was changed and MSA 30 connected all arrays were succesfully detected. A firmware for 6i and 6404 is 2.68A. What must I do in such situation to move arrays? Whi 6404 didn't load array configuration from disks? Or such moving is not possible?
2 REPLIES 2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-21-2006 06:52 PM
тАО08-21-2006 06:52 PM
Re: Moving MSA30 to another controller
If possible Post an ADU report from the DL380 G4 here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО08-22-2006 07:21 PM
тАО08-22-2006 07:21 PM
Re: Moving MSA30 to another controller
Here is report form ADU
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP