HPE Community
ProLiant Servers (ML,DL,SL)
1753797 Members
8164 Online
108805 Solutions
New Discussion

NIC/Nerwork problem with RH7.1 on DL380G3

 
Eddie Li
Occasional Contributor

‎06-23-2003 10:52 PM

‎06-23-2003 10:52 PM

NIC/Nerwork problem with RH7.1 on DL380G3

Due to customer's application requirement, I use RedHat 7.1 on DL380 G3. Things are going fine during installation. After login and started config the network card, problems occurd.
I can only see 'lo' by using ifconfig -a, and cannot see the 'etho' or 'eth1'
I tried download the bcm5700 driver from hp web pages but only see RH7.2 are available with version 2.2.23-1 but it got conflict while building in RH7.1
Then I tried the ver 2.0.25-1 which is for G2 and RH7.1 but cannot initialise the device during installation "insmod".

Any advice will be appreciated.

Thanx!

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.