HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

NIC Team not initializing on boot

 
KarimK
Frequent Advisor

NIC Team not initializing on boot

All,

I have a DL380G5 configured for teaming

2x NC360T Nextwork Adapters connected to a CIsco Switch with LACP enabled

The problem i have is whenever the servers is rebooted the Teaming doesn#t come back on line and it says it's aquiring a network address although the IP is static.

Has anyone seem this problem before?

Karim
1 REPLY
Lmm_1
Honored Contributor

Re: NIC Team not initializing on boot

I´ve seen this issue before, is there any specific reason for using LACP? You can use a SLB team instead, on the switch side it requires an static channel instead of LACP (Cisco Mode On vs Mode Active), at the server level you will get the same 2GB tx/rx. The issue seems to be timing issue with tcp/ip stack and the driver, Im not aware of a solution yet.