HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

NIC teaming

 
jason bliss
Occasional Visitor

NIC teaming

I have a prolient server and want to team the NICs. I have two in a team and they are connected to a Cisco Swtich (3659g). I have it set up for LACP. The ports keep dropping/flapping. Cisco recommends to turn off "hard code" the cards not to autonegotiate Etherchannel. Any one have a doc or know how to do this?
2 REPLIES
Lmm_1
Honored Contributor

Re: NIC teaming

Basically you need to use an automatic team mode and then the cisco interfaces as channel-group mode active, if it keeps flapping then try cisco etherchannel, channel group mode on, and auto team type, it will give you the same as LACP, 2GB TX/RX.

rgds
lmm
jason bliss
Occasional Visitor

Re: NIC teaming

Thanks I'll give it a try and let you know.