Community
ProLiant Servers (ML,DL,SL)
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

NMI error in DL380e G8 when LSI SAS-9211-8i [CTRL] C command issued

 
dhenzler
dhenzler
Occasional Contributor

2 weeks ago

2 weeks ago

NMI error in DL380e G8 when LSI SAS-9211-8i [CTRL] C command issued

Building a FreeNAS system on the DL380e G8 server.  Board being entry level has only b120i which I disabled.  Installed an LSI SAS-9211-8i (IT mode) in Slot 1 and it works, providing access to all 12 of my LFF drives.  However if I attempt to do a control-C to check the status... I get the RED SCREEN with NMI Error.  I flashed this card from IR mode and updated the BIOS on it as well using flash from Broadcom's website.  It's the P20 version.

It doesn't seem to affect operation, only the querry of configuration.  Is this correctable?

I've turned off the on-board b120i device in BIOS.

Dave

0 Kudos
Reply
1 REPLY 1
Shwetha3
Shwetha3
Frequent Advisor

2 weeks ago

2 weeks ago

Re: NMI error in DL380e G8 when LSI SAS-9211-8i [CTRL] C command issued

Hello Dave,

Please contact the vendor of installed card to check its compatibilty with Proliant DL380e Gen8 server. 

The compatible Firmware/Driver should be tested and provided from this vendor.

Regards,

Shwetha

 

I am an HPE Employee
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.