HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

NT Workstation

 
Ayman Altounji
Valued Contributor

NT Workstation

Can NT Workstation be installed instead of using NT Server or 2000 Server? This system is not being used as a server station, but only as a workstation.
1 REPLY
Ayman Altounji
Valued Contributor

Re: NT Workstation

Yes, but Smartstart can't be used so:

In order to install NT on a system with a current Compaq SCSI controller, you need to create the 3 NT install disks from the NT CD. Use the "WINNT /OX" command to do this. Then, when the Smartstart manual install is done, boot from those disks - without the NT CD in the drive until asked. Choose "custom" for the install mode (F6 key) and skip detection on mass storage. Specify an unlisted controller and use the Compaq NT 4.0 SSD for the drivers. Then specify a secondary controller and use the NT "IDE/Atapi" driver. You can also use the SSD for the NIC drivers (also likely to be out of date in NT).

NT 4.0 SSD