ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

NVRAM reset switch

 
F. Smith
Occasional Visitor

NVRAM reset switch

Hello!

Which is the correct procedure to reset the NVRAM on a DL360G3? SW6 on the system board must be switched on, but has it to be switched off immediately after? Or has it to be in "On" state for a certain period of time?

Thank you!
1 REPLY
KarloChacon
Honored Contributor

Re: NVRAM reset switch

hi

procedure

1. Power down the server.
2. Remove the server cover.
3. Locate the System Maintenance Switch, position S6, and move the switch to the "On" position.
4. Power the server back on until Power-On Self-Test begins.
5. After POST has started, power-cycle the server off.
6. Move the System Maintenance Switch back to the "Off" position.
7. Replace the server cover and power on the system. The server will boot
Didn't your momma teach you to say thanks!