HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Need to monitor the RAID controllers

 
AJNinjaPM
Occasional Collector

Need to monitor the RAID controllers

Hi,

 

I am trying to fgirue out how to monitor a RAID controller health on a HP server.

I have been looking all over but hardly found anything conclusive.

 

Any help will be highly appreciated. Thanks.

1 REPLY
Fritsch James
Frequent Advisor

Re: Need to monitor the RAID controllers

Which server do you want to monitor? Which Operating System do you use?

Usually you would configure SNMP and install HP Management Agents Software.

You can see the health status on HP Management Homepage or also via ILO. (at least on most of the ProLIant Servers). The older 100-Series servers only support very basic monitoring.