ProLiant Servers (ML,DL,SL)

No Display Signal

Go to solution
Occasional Advisor

No Display Signal

Hi all

Have  DL380p G8, display singal is getting lost after sometime

i tried directly connecting the monitor frrom both front and rear VGA ports on the server

it is only working after a reboot

even RDP also not working, getting a black screen after connecting

pleease advise


Re: No Display Signal

Hi Giridar_SL

>>Suggesting you to update the server BIOS/ILO firmware's to the latest versions and reboot the server.
>>Then Shutdown the server.
>>Disconnect all the power source from the server [power supply from the wall outlet and remove all the PSU (power supply units) from the server].
>>Press and hold the power button for 15-30 seconds. Then try to power on the server and check for the results.
>>Restore the system default in Server BIOS.
>>Also you can perform the minimum configuration test. Refer the document :-

Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo