- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- P410i Array Controllers Handling Predictive Failur...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-01-2016 01:06 PM
06-01-2016 01:06 PM
P410i Array Controllers Handling Predictive Failures
I've had the same problem on various servers using P410i array controllers. Replacing drives in predictive failure with known good drives will not clear the predictive failure. The drives are replaced and go through the rebuild process only to come back online and starting flashing the predictive failure again. As far as I can tell there are no problems. I've had to go so far as to replace all the drives with exactly the same part number/model number drives and completely redo the array and reload the OS. It's acting like the errors aren't cleared out of the controller when the drive is replaced although the ADU shows the new serial numbers. Firmware is up to date and the problem has been occuring through a couple of releases. Any ideas as I currently have one incedent outstanding and I don't want to have them start from scratch just to clear the led.