ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

P410i Controller running at 100% CPU usage

Jason_212
Occasional Advisor

P410i Controller running at 100% CPU usage

I noticed that on my new DL360G6 servers (running windows 2003) that the HP Homepage shows the P410i controller's "CPU Usage" is running at 100% eventhough the server is not doing anything. I am running 8.30 SupportPaq. Anybody seen this or have a recommendation?
8 REPLIES
Pete2010
Frequent Advisor

Re: P410i Controller running at 100% CPU usage

Mark Coney
Occasional Contributor

Re: P410i Controller running at 100% CPU usage

I updated to the current version 2.74, we will see how it goes after we can get a reboot
Doug_77
Occasional Contributor

Re: P410i Controller running at 100% CPU usage

I am setting up a brand new dl380 g6 and have the latest software (2.74) for the P410i controller and I am still getting 100% usage in the HP Managment viewer? Also some of the graphics (like drive capacity limits) show up as a red X. Any ideas.

Sorry for the thread jack. But this was the only one I found with info on the P410i 100% usage problem.

Thanks

Doug
gabryp
Occasional Visitor

Re: P410i Controller running at 100% CPU usage

the same problem...
www.sysblog.it
marcus1234
Honored Contributor

Re: P410i Controller running at 100% CPU usage

boot from fw cr 8.7 update all firmware
not use psp pack cd 8.3 update all drivers

reboot if issue persists remove cache and battery from controller
it wil complain

reboot again add cache no battery let it complete post , make sure cache is on tight
reboot add battery too now reboot and enjoy:)

if issue persists boot from software cd and run diagnostics in survey mode and then adu rapport post it here i will look at it

This is how we thank each other in the forum

http://forums11.itrc.hp.com/service/forums/helptips.do?#33

Enjoy:)


Taifur
Respected Contributor

Re: P410i Controller running at 100% CPU usage

Hi,

U can check that issue by using upgraded firmware and use minimum process from ur OS

Cheers,
Taifur

Re: P410i Controller running at 100% CPU usage

Hi,

Controller card Cache Status have been Permanently Disabled ?
Kind Regards,
Erdogan.
I am HPE Employee

If this helps you with your issue, please click the thumb to register a Kudo.
If it resolves the issue, please consider marking it as an Accepted Solution.
The comments in this post are my own and do not represent an official reply from the company. No warranty or guarantees of any kind are expressed in my reply.
ddaloia
Occasional Visitor

Re: P410i Controller running at 100% CPU usage

Reset the System Bios (not the array bios) back to Defaults and reboot server. This fixed the issue for my BL460c G6 with the P410i controller. I noticed today HP removed driver version 6.18.2.64 from their website for Windows 2008 x64. 6.18.0.64 seems to be the latest at this point.

Cheers.