PCI Bus Error Slot 0, Bus 0, Device 0, Function 0

[PZel]

There were some issue's with the PCI-X riser board in the DL360G5. The one that has no problems -according to HP- has SPN 436912-001.
Is that the same you're using ??

[PatrickBurwell]

We have ~500 ProLiant xw2x220c Blade Workstations and we see these errors on some of them. Our System ROM is V04  11/02/2008.

[juanrm2112]

We had this issue happening in most of our Proliant Blades, and it ended up being the Smart Array firmware version which had some issues.

Here are the few things that most of the blades that have failed had in common:

Server:

HP ProLiant BL460c G6 (Blades)

Array:

Smart Array P410i

Firmware Version:

Anything lower than 5.06

OS:

SLES 11 SP1

...so far there have been no more crashes with the upgrade to 5.06.

[Spectroscopy]

This is a NMI case which has the following agenda to be followed through such as Datasheet inspection of Intel Chipset register ++ PIC SIG configuration mapping with Uncorrectable error mask and error severity which will take time to deduce

 Need to analysze AHS log . If AHS gives the following defination under Decode NMI then By looking at the file and the NMI Dump it has the following error : flow_control_protocol_error_mask , Also the error status register bit 15:1 if high that denotes the error status to be true and not pseudo. Find the screenshot attached.

On Reg 154h there is error code of 0006203 which gives us the trace for error severity. This takes us to the next level of troubleshooting which will point towards the Uncerrsrv from INtell datasheet register which will give the unplanned down for more info contact me