ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

PRoliant DL320 doesn't power up after Halt command

Andrea Zanetti
Occasional Visitor

PRoliant DL320 doesn't power up after Halt command

I've recently had to work to an hold proliant DL320 G! server. After installing linux (debian etch 4.0) everything worked fine, i give the halt command and brought the server in place BUT when i pressed the power up switch nothing happened... I really dont know what to do...
5 REPLIES
Steven E. Protter
Exalted Contributor

Re: PRoliant DL320 doesn't power up after Halt command

Shalom,

1) unplug and replug the server.
2) test if the power button, physical works.
3) Connect to the ilo card if configured
4) Contact HP Hardware support.

SEP
Steven E Protter
Owner of ISN Corporation
http://isnamerica.com
http://hpuxconsulting.com
Sponsor: http://hpux.ws
Twitter: http://twitter.com/hpuxlinux
Founder http://newdatacloud.com
Andrea Zanetti
Occasional Visitor

Re: PRoliant DL320 doesn't power up after Halt command


Thank you for the fast reply!

I did the first two steps than skipped the step three (the server haven't a ilo card). When re-inserted the plug the server self powered on and emits one long beep and three short beeps. Before contacting the hp hardware supporti want to try to solve the problem by myself (warranty is over... and the server is old...)
SKR_1
Trusted Contributor

Re: PRoliant DL320 doesn't power up after Halt command

Something hardware issue!!!

Try to do refix the memory on the server , if you can do it then only. Otherwise you may need to contact HP H/W support.

Thanks

SKR
Gokul Chandola
Trusted Contributor

Re: PRoliant DL320 doesn't power up after Halt command

Hi,
Please make dust free to server inside and then reconnect memory.
Due to dust this problem is generally occure.
May be you will get resolve this problem.
Otherwise you have to Take HP Support.

Regards,
Gokul Chandola
There is always some scope for improvment.
ssimonek
Occasional Visitor

Re: PRoliant DL320 doesn't power up after Halt command

Try to unplug the power cable.
Press power button.
Normaly, the ethernet leds are now turned off.
Plug the power cable, and press the power button.

If nothing's better => verify the alimentation box, you can test the DC output or try with another one if you have a second DL320 server :)