Possible to disable RAID on DL385 G2 servers?

[Damian48]

Hello,

I am new to servers and am trying to install Linux on my machine; unfortunately, if RAID 0 or RAID 5 is selected, Centos7 does not see my hard disk. I'm wondering if somebody can assist me with instructions for disabling RAID mode in DL385 G2 servers. I want to utilize it without the Raid mode enabled.

I appreciate your time in advance

[support_s]

System recommended content:

1. Advisory: Disabling Integrated Lights-Out 2 (iLO 2) IRQs Within the ROM-Based Setup Utility (RBSU) on ProLiant DL385 G2 and ProLiant DL585 G2 Servers May Cause the System to Stop Responding Before Power-On Self-Test

2. Advisory: ProLiant DL385 G2 and ProLiant DL385 G5 Server - If an Embedded Network Interface Controller is Disabled in ROM-Based Setup Utility (RBSU), the Server May Not Perform Power-On Self-Test (POST)

If the above information is helpful, then please click on "Thumbs Up/Kudo" icon.

Thank you for being a HPE community member.

[Cali]

This Server uses the Smart Array P400 Array Controller.

Maybe this Thread Helps you:

Possible use of driver for HP SmartArray P400(cciss) - CentOS

Cali