Power Supply failure

[Ayman Altounji]

this 1600 states Power Supply failure at bay 3/2/1
the server runs fine, there's nothing wrong with the PS'
the issue is the fact I have to press F1 to continue, so I cannot re boot this system remotely. any has seen this problem before?

[Ayman Altounji]

You can disable the F1 Prompt - but I would be more curious to find the actual solution as to why.

I am guessing this has the 3 hot-pluggable supplies - if it is showing ALL failed - well that is impossible. I would look to make sure your firmware is at the most recent level.

If you need to disable the F1 prompt - hit F10 when you are prompted. At the first screen - hit Ctrl A - this will enable the Advanced Mode - and it will tell you that it is enabled. Run the Sys Config - Go to Review or Modify - Scroll Down to something called F1 Prompt - or something of that nature. Toggle until it says disabled. Save and Exit. This will show the F1 Prompt for 15 seconds I believe - but it will go passed eventually.