ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

ProLiant DL380p Gen8 - предупреждение {ProLiant DL380p Gen8 - warning}

 
Highlighted
Konstantin1987
Occasional Advisor

ProLiant DL380p Gen8 - предупреждение {ProLiant DL380p Gen8 - warning}

Добрый день коллеги.

Имеется сервер ProLiant DL380p Gen8, на котором установлен esxi 6.0.0

Сегодня в VMware vSphere Client обнаружил предупреждение.

Полез в ILO, там все ОК.

До этого месяца 3-4 назад менялась батарейка RAID контроллера (Part number: 660093-001) т.к. в ILO был ERROR на нее. После замены все ОК.

Как обнулить данное предупреждение в VMware vSphere Client ??

Google Translation

Good afternoon colleagues. There is a ProLiant DL380p Gen8 server on which esxi 6.0.0 is installed Today, VMware vSphere Client has detected a warning. I got into ILO, everything is OK there. Until this month, 3-4 months ago, the battery of the RAID controller (Part number: 660093-001) was changing.
in ILO there was an error on her. After the replacement, everything is OK. How to reset this warning in VMware vSphere Client ??

Спасибо1.JPG2.JPG3.JPG4.JPG

2 REPLIES 2
Highlighted
I_AN
Visitor

Re: ProLiant DL380p Gen8 - предупреждение {ProLiant DL380p Gen8 - warning}

Hello,

1. Please find the below link to Reset Health Status Sensors in the vSphere Client:

https://docs.vmware.com/en/VMware-vSphere/6.7/com.vmware.vsphere.monitoring.doc/GUID-B862E89B-77B7-4970-BF25-463D06FF81C1.html?hWord=N4IghgNiBcIEoFMDOCAuACAEgyqAW6AyqmKgK5JEIB2SA9gE5IgC+QA

2. Below steps/link to clear the warnings and errors in the Hardware Status tab of a host within VMware vCenter Server.

To clear warnings and errors:
  1. Click the Hardware Status tab.
  2. Click the System event log view.
  3. Click Reset event log.
  4. Click Update to clear the error.
  5. Click the Alerts and warnings view.
  6. Click Reset sensors.
  7. Click Update to clear the memory.
If the issue persists, restart the management agents:
  1. Connect to the ESX/ESXi host using SSH.
  2. Run this command to restart the sfcbd service:

    In ESX: /etc/init.d/sfcbd-watchdog restart
    In ESXi: services.sh restart
     
  3. localcli hardware ipmi sel clear  (This command above helps in clearing memory alert not just IPMI alert)
  4. Click Update.

 

Regards,

 

I am a HPE Employee
Highlighted
Konstantin1987
Occasional Advisor

Re: ProLiant DL380p Gen8 - предупреждение {ProLiant DL380p Gen8 - warning}

Спасибо, помогло.