Problem of controler 6i with hp proliant DL380 G4

[sassou]

Hi,
Trying to install a new DL 380 G with smart start, I get this error :
1776-SLOT 0 scsi bus terminator error.
And I could not install the the the Controler HP Smart Array 6i with is detected by the system.
So my system could not dectect any disk for installation
Thank you for your help

[ramesh_naik_ · Accepted solution]

Hi Kuzo,


The SCSI bus is not properly terminated when internal and external drives are attached concurrently to the same SCSI bus.
The indicated SCSI bus is disabled until this problem is resolved.
Turn off the server power and check the cabling to the specified SCSI port.

Regards,
rmn

[Caster Troy]

check for cabling of SCSI ports.

[RGP]

Hi,
Are you using the BLUE "point to point" cable or the grey flat cable with a terminator?

You should be using the BLUE BLUE "point to point"
Rgds,
Roy

[sassou]

Hi,
I just verify the terminator.
My problem is du in the fact that the scsi bus is not terminated.
I have one terminator but after that another scsi bus start
Thank you for your help
KUZO