HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Problem to access the data in HP Proliant DL380 G6

 
VIPIN-RCE
Occasional Visitor

Problem to access the data in HP Proliant DL380 G6

Hi,

This is vipin here, last couple of days we are facing a problem with our HP server to access the data, below mentioned are the issues kindly share your thoughts and suggesstions to come out from the situation and recover the data.

1. initially it was showing error message( attempting to boot from hard disk (C:), missing operating system.

2. after restoring the operating system, logical drive was disabled, when it was enabled it is showing the logical drive but when  i click on that it is showing a dialog box saying format disk.

i am attaching the images herewith the above mentioned.

Regards

Vipin

 

 

 

2 REPLIES
PiterParker
Valued Contributor

Re: Problem to access the data in HP Proliant DL380 G6

Hi VIPIN. 

 

I can see one of the HDD is faulty from the attached photos. 

Could you tell me what was the configuration of the HDDs? 

System was in RAID 1?

Disk D was configured on different set of drives (RAID) ?

 

Regards, 

Piotr

 

Edwin Eppel
Valued Contributor

Re: Problem to access the data in HP Proliant DL380 G6

Have you run ILO or the Array Configuration Utility to check the status of the array? The amber LED indicates a fault (check the Maintenace Guide for fault codes). Is the drive with no LEDs on a spare?