HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
cancel
Showing results for 
Search instead for 
Did you mean: 

Prolaint 6400R

 
FRED JEWELL JR
Occasional Advisor

Prolaint 6400R

Using a RIB card for remote access, problem is on boot error message 304 keyboard. Only way to clear error is to connect a keyboard to the keyboard T connection RIB cable. I have tried clearing CMOS, Flashed BIOS and updated Firmware and changed RIB and RIB cable. Reset sever with maintence mode SW, booted up without error but error returned with second boot up. Does anyone know of a fix, not all of my 6400R are having this problem with this keyboard error.
3 REPLIES
Bob Compono
Occasional Advisor

Re: Prolaint 6400R

As I recall you go into the hardware setting and tell it you want a "hot swappable" keyboard set up. Then it shouldn't care if a keyboard is connected or not.
FRED JEWELL JR
Occasional Advisor

Re: Prolaint 6400R

We need the keyboard to work thru the RIB cable connection. If it only disables the keyboard error that's not going to work when we try to access the server thru the RIB connection.
Dave_180
Valued Contributor

Re: Prolaint 6400R

Also, in the Sys Config...

When prompted - hit F10.
Hit Enter
Hit Ctrl A - this will enable Advanced Mode
Highlight System Config
Arrow down to Review & Modify Settings
About half way down the page - there is a setting to stop on F1 (I don't remember the exact message).

The advanced mode offers a lot of different choices you should find entertaining to play with. The stopping on F1 prompt I think will probably suit you best.