HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant 1600r 6/266 M1

 
Earl Thompson Jr.
Occasional Contributor

Proliant 1600r 6/266 M1

Server has been down for approx. three months. When restarting, it reports data recovery and to press F1 to start auto recovery or F2 to continue. Pressed F1, appeared to start recovery, drive lights flashing and then has statement:

CPQDA386: The CPQ Smart-2 Slot 1 Dsk1 DDG devies is queued to begin rebuilding data on the new drive replacing the previously failed drive. Left for 18 hours and never rebuilted data. Replaced the drive with another and had the same statement. Any suggestions will be greatly appreciated. The server has Novell Netware 4.11 OS. Thanks Earl
2 REPLIES
e4services
Honored Contributor

Re: Proliant 1600r 6/266 M1

Sounds like the data is corrupted and/or there is another failed drive.
Hot Swap Hard Drives
Anthony Koay
Occasional Advisor

Re: Proliant 1600r 6/266 M1

Hi Earl,

Just a short note to share :-

You can use the ADU utility to test the controller & the HDDs. It's non-destructive & will generate a report.zip which contain report.txt. Open up & review it as it will provide info such as which drive is having problem.
Here's the link : http://h18000.www1.hp.com/support/files/server/us/download/23024.html

You can also use the DAAD utility that comes with the older version of SmartStart CD such as v5.x & v4.x, ship along with your server.

I believe you are having more than just 1 HDD facing problems like bad sectors or time-outs. This could be preventing the logical drive from rebuilding. Remember, the DDG (also known as RAID-5) only tolerate 1 disk failure.

Cheers!

AK