HPE Community
ProLiant Servers (ML,DL,SL)
1753440 Members
4611 Online
108794 Solutions
New Discussion

Proliant 3000 processor error

 
Johnny Creasy
New Member

‎07-22-2004 01:47 AM

‎07-22-2004 01:47 AM

Proliant 3000 processor error

I have a 3000/300mhz dual processor server that is giving me processor 1 error I have replaced the processor and it still gives the same error. Do I need to run smartstart after replacing the CPU? Or can I put the terminator board back in and just have one processor in slot 2 and the terminator board in slot 1. I am running NT Server 4.0 with the multiprocessor kernel.
0 Kudos
Reply
1 REPLY 1
Leon Rosier
Respected Contributor

‎07-22-2004 02:52 AM

‎07-22-2004 02:52 AM

Re: Proliant 3000 processor error

Hi,

You have to "repair" the error message in the F10 setup. I think it is configure this system and then it will ask you whether it is replaced/repaired.

Leon
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.