HPE Community
ProLiant Servers (ML,DL,SL)
1753487 Members
4485 Online
108794 Solutions
New Discussion

Proliant 3000 with Digiboard Ports/XEM Multiserial

 
Carlos Moura_1
Occasional Contributor

‎12-01-2003 06:13 AM

‎12-01-2003 06:13 AM

Proliant 3000 with Digiboard Ports/XEM Multiserial

I am trying to install a multiserial board in my Proliant 3000 but the config utility shows an error message saying " EISA config slot mismatch, device not found". What is wrong?
0 Kudos
Reply
1 REPLY 1
Frank Kaufman
Honored Contributor

‎12-01-2003 03:57 PM

‎12-01-2003 03:57 PM

Re: Proliant 3000 with Digiboard Ports/XEM Multiserial

Your ProLiant 3000 is the earlier model. You need to run the F10 system configuration utility in advanced mode, and delete any add-on cards that are in the configuration but do not actually exist in the system. You will also need to tell the configuration about the new card you are installing.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.