HPE Community
ProLiant Servers (ML,DL,SL)
1753781 Members
7433 Online
108799 Solutions
New Discussion

Proliant 3000 with NC6132 Fibre NIC

 
Phil Black_1
New Member

‎10-01-2003 04:22 AM

‎10-01-2003 04:22 AM

Proliant 3000 with NC6132 Fibre NIC

I have a Proliant3000 running NetWare 6 sp2a- dual PIII 500 mhz processors 1.5gb RAM. I also have an NC6132 nic in this server. I can see light from the switch to the server. Likewise, the server sees the link. The transmit side of the server NC6132 does not seem to be transmitting. I have cleaned the contacts, reinitialized system. The latest NIC drivers have been applied and the server rebooted PRIOR to configuring the NIC. Both sides of the fibre cable are good - when flipped, I see the switch transmitting through either cable. Short of rebooting the server, any other suggestions?
0 Kudos
Reply
1 REPLY 1
Phil Black_1
New Member

‎10-01-2003 04:34 AM

‎10-01-2003 04:34 AM

Re: Proliant 3000 with NC6132 Fibre NIC

I should add that at the server console I can ping the ip address assigned to the fibre module and I do have link lights on the NIC. It is connected to the LAN via 3Com switch. The 3Com switch states that the link is disabled.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.