- Community Home
- >
- Servers and Operating Systems
- >
- HPE ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Re: Proliant 400 SmartStart/System Erase not worki...
ProLiant Servers (ML,DL,SL)
1748149
Members
3522
Online
108758
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-03-2005 03:43 AM
08-03-2005 03:43 AM
Proliant 400 SmartStart/System Erase not working
I have a Proliant 400 (400MHz) I would like to re-install the OS. When I boot with the SmartStart CD-ROM, it states that the system or some of the components have been previously configured. When I the select "Run System Erase Utility", after a warning and a boot cycle, the message "This version should be run from SmartStart Only!" is displayed.
I also tried with the System Erase Disk. Then I get the "162-System Options Not Set", but SmartStart gives the same behaviour.
If I start the WinNT setup manually and provide the SCSI Controller driver, the setup accepts it but does not "see" any HDDs attached to it (the disk is there, I can access it in DOS mode)
I also tried with the System Erase Disk. Then I get the "162-System Options Not Set", but SmartStart gives the same behaviour.
If I start the WinNT setup manually and provide the SCSI Controller driver, the setup accepts it but does not "see" any HDDs attached to it (the disk is there, I can access it in DOS mode)
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2005 06:50 PM
10-08-2005 06:50 PM
Re: Proliant 400 SmartStart/System Erase not working
Pls update the server ROMPaq to version 4.06 A
http://h18000.www1.hp.com/support/files/server/us/download/7555.html
http://h18000.www1.hp.com/support/files/server/us/download/7555.html
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP