ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant 7000 NVRAM

Drew Miller_3
Occasional Contributor

Proliant 7000 NVRAM

I am having two problems but they could be related. Proliant 7000 PIII Xeon 500 Mhg. I do not have the server running all the time just when I need to use it. When I power it up I get the following message "Controler NVRAM has automaticly been updated for use in this system.System will now reset for controller NVRAM changes to take effect" This followed by a normal reboot. Any reboot after that is fine unless I power down over night. Problem two, Whenever I change the drive array config by adding arrays, fdisk will not recognise the logical drives unless I first open the server and set the dip switches on the IO card to sw 1 and 6 to on reboot the server then shut the switches back to off and reboot again. Then fdisk will see the logical drives so I can set the dos partition. Can anyone help?