HPE Community
ProLiant Servers (ML,DL,SL)
1753599 Members
6145 Online
108796 Solutions
New Discussion юеВ

Re: Proliant 800- Deleted Sys partition-Still

 
SOLVED
Go to solution
Tudor Moore
Occasional Contributor

тАО05-01-2003 05:14 AM

тАО05-01-2003 05:14 AM

Proliant 800- Deleted Sys partition-Still

Sorry, Thought I had this one sorted.
I have used maintance switch to clear NVRAM but after going thru POST and RAID Setup I still get the F1/F10 Prompt. F10 being partition utils which isn't there. If I go thru the F1-continue, then I get Default Sys Config Install-Run System Conf to View/Mod Settings then a list of O/S's. It did acknowledge that Maintenance mode is on but apart from that still won't boot from Floppy. Any assistance is much appreciated. Thanks
0 Kudos
Reply
2 REPLIES 2
Terry Hutchings
Honored Contributor

тАО05-01-2003 06:29 AM

тАО05-01-2003 06:29 AM

Solution

Re: Proliant 800- Deleted Sys partition-Still

Have you tried a different floppy drive? I would not recommend running the system configuration utility with "maintenance mode" on, since nothing done in there will be saved with that switch on.
The truth is out there, but I forgot the URL..
Reply
Tudor Moore
Occasional Contributor

тАО05-02-2003 07:12 AM

тАО05-02-2003 07:12 AM

Re: Proliant 800- Deleted Sys partition-Still

The smallest thing-Changed floppy drive-boots fine. Thanks V. Much.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.