ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant 800 IDE interface

Dany Joly
Occasional Visitor

Proliant 800 IDE interface

We bought a Compaq Proliant 800 600 MHz, and the system seems to work fine except for the IDE controller. Even with diffeent cables and different CD-ROMS / hard drives, the system does not seems to detect anything. Is there a way to enable / disable IDE controller?
1 REPLY
Prashant (I am Back)
Honored Contributor

Re: Proliant 800 IDE interface

Hi,

solution will be :
To resolve this issue, ensure that the Cable Select/Master/Slave jumper located on the back of the CD-ROM is set to Cable Select (jumper between C and S). The connector labeled System Board should be securely attached to the system board, and the CD-ROM should be attached to the connector labeled Drive 0.


Regards,
Prashant S.
Nothing is impossible