HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant DL180se G6 jumper help

 
ThisTNTSquid
Occasional Contributor

Proliant DL180se G6 jumper help

I would like to recover the BMC as the last firmware upgrade failed. According to the manual, it tell me to use J27 jumoer switch and set to D. However, i have no idea on how to do that.

Can anyone out there can tell ne how to use maintenance jumpers?
2 REPLIES
PGTRI
Honored Contributor

Re: Proliant DL180se G6 jumper help

hi,

I'm not usre if it is a jumper or switch. Just take a look at it and switch it to on or of or pin it to position d.

thanks

 

How to Say Thank You? Just click the KUDOS!
Edwin Eppel
Valued Contributor

Re: Proliant DL180se G6 jumper help

Server Maintenance and Service Guide is at

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=3896018&docLocale=en_US&docId=emr_na-c01727957

Page 121 shows the system board layout and jumper location. Page 122 shows the required jumper settings. Should be labeled on the system board.