HPE Community
ProLiant Servers (ML,DL,SL)
1753727 Members
4889 Online
108799 Solutions
New Discussion

Re: Proliant DL380 G4 No POST after Cleaning

 
Motealleh
Occasional Visitor

‎10-04-2013 08:00 AM

‎10-04-2013 08:00 AM

Proliant DL380 G4 No POST after Cleaning

Hi, I've 3 HP Proliant DL380 G4 Servers which do not pass POST after cleaning with blower. they stop on 01100001 (0x61h) state (iLO STATUS LEDs on the main /board) during POST Progress. i shutdown the servers but not plug out the power, then remove the fans and clean them with the blower, then clean inside the servers with blower too, after that when I turn on the each server there is no video signal on the monitor. when i remove the RAMs the server check them and make beeps. I don't know what to do?
 
0 Kudos
Reply
1 REPLY 1
Suman_1978
HPE Pro

‎10-06-2013 10:24 PM

‎10-06-2013 10:24 PM

Re: Proliant DL380 G4 No POST after Cleaning

Hi,

 

Refer to Minimum Hardware Configuration for Troubleshooting.

 

You can try clearing NVRAM from the System Maintenance Switch.

 

Thank You!
I am a HP employee.


I work for HPE.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]

Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.