Proliant ML330 G3 - Removing the Case

[Kevin Jervis]

Dear all,

We are a small company who puchased above server about a year ago. We have since purchased RAM to install and improve the performance. However we cannot seem to understand how one is supposed to remove the case. The side panels do not seem to be screwed in, but they don't seem to slide either.

I have attached pictures, sorry for the poor quality, taken on my v600.

If anyone can help, would be much appreaciated.

Kind regards,
Kevin

[Markus Neunstöcklin]

Hi Kevin,

did you try to remove the front pannel, there should be some screws to remove the side pannel.

Hope this helps!

Markus

[Stephen Kebbell · Accepted solution]

Hi Kevin,

as Markus says, you pull off the front panel (grab it at the bottom, and pull), and then you can slide the side panels forward. Can't remember if there are screws holding the side panels in place.

Regards,
Stephen

[Kevin Jervis]

Thanks Guys,

Having identified the front as being point of access, it was a piece of cake. There was just a single screw to remove and the panel just slid off.

Thanks once again

[Stephen Kebbell]

No problem!
If you find answers useful, could you please assign points, depeding on how useful the info was?
Have a look here:
http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Thanks, and happy upgrading!
Regards,
Stephen