ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant ML330 G3 - Removing the Case

SOLVED
Go to solution
Kevin Jervis
Occasional Visitor

Proliant ML330 G3 - Removing the Case

Dear all,

We are a small company who puchased above server about a year ago. We have since purchased RAM to install and improve the performance. However we cannot seem to understand how one is supposed to remove the case. The side panels do not seem to be screwed in, but they don't seem to slide either.

I have attached pictures, sorry for the poor quality, taken on my v600.

If anyone can help, would be much appreaciated.

Kind regards,
Kevin
4 REPLIES
Markus Neunstöcklin
Occasional Visitor

Re: Proliant ML330 G3 - Removing the Case

Hi Kevin,

did you try to remove the front pannel, there should be some screws to remove the side pannel.

Hope this helps!

Markus
Stephen Kebbell
Honored Contributor
Solution

Re: Proliant ML330 G3 - Removing the Case

Hi Kevin,

as Markus says, you pull off the front panel (grab it at the bottom, and pull), and then you can slide the side panels forward. Can't remember if there are screws holding the side panels in place.

Regards,
Stephen
Kevin Jervis
Occasional Visitor

Re: Proliant ML330 G3 - Removing the Case

Thanks Guys,

Having identified the front as being point of access, it was a piece of cake. There was just a single screw to remove and the panel just slid off.

Thanks once again
Stephen Kebbell
Honored Contributor

Re: Proliant ML330 G3 - Removing the Case

No problem!
If you find answers useful, could you please assign points, depeding on how useful the info was?
Have a look here:
http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Thanks, and happy upgrading!
Regards,
Stephen