ProLiant Servers (ML,DL,SL)
1748058 Members
5087 Online
108758 Solutions
New Discussion юеВ

Re: Proliant ML350 making morse code sounds

 
Kris Wegan
New Member

Proliant ML350 making morse code sounds

Not sure if this is hardware, hard drive or what????? It booted up ok but it is still making these beeps. Event viewer shows nothing strange even after re-booting.
3 REPLIES 3
Sunil Jerath
Honored Contributor

Re: Proliant ML350 making morse code sounds

Hello Kris,
You might want to check the cabling or any loose components. Or it could be that one of the HDDs is about to choke. Just reseat RAM as well.

Regards,
PDarmanin
Frequent Advisor

Re: Proliant ML350 making morse code sounds

Hi Kris,

I think that u have a faulty hard disk. Check the hard drive status leds you might find one blinking red. Replace the drive with identical hdd type and once inserted rebuild should start automatically.
Data loss did not occur since u have a RAID level 1, 5 or ADG.

Hope this Helps

Pierre
Kris Wegan
New Member

Re: Proliant ML350 making morse code sounds

Thanks for the suggestions.

After rebooting a couple more times, we found that the C: drive was full and needed cleaning up. It did not make anymore beeping sounds after that so not sure why it was even doing it. There were no red lights on any of the LEDs or hard drives.
We are working on some solutions for this old server and if we need to replace soon anyways.