ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Proliant ML350G4 array diagnostic utility log help

 
SOLVED
Go to solution
Danijel Baloh
Occasional Contributor

Proliant ML350G4 array diagnostic utility log help

Hi im am currently trying to diagnose and fix a problem involving the above mentioned server,i started ADU and i got the following error:

SCSI Port 1 Drive ID 2 has exceeded the following threshold(s)
Pred failure errors
SOLUTION: Please replace this drive when conditions permit.
SCSI Port 1, Drive ID 2 ... S.M.A.R.T. predictive failure errors have been
detected in the factory Monitor and Performance data. SOLUTION: Please
replace this drive when conditions permit.
SCSI Port 1, Drive ID 2 ... S.M.A.R.T. predictive failure errors have been
detected in the since power Monitor and Performance data. SOLUTION: Please
replace this drive when conditions permit.

Now i was wondering if there is any other way to fix the problem short of having the disk replaced and if there is could some1 point me in the right direction(maybe a link on how to...).
p.s.I have attached ADU log in the post.

Thanx
4 REPLIES
ramesh_naik_
Esteemed Contributor

Re: Proliant ML350G4 array diagnostic utility log help

Hi Danijel,


# Upgrade the Smart Array 641 Controller firmware as preventative maintenance. The firmware is available here:
http://h18007.www1.hp.com/support/files/storage/us/download/24879.html

# Upgrade the hard drive firmware as preventative maintenance. The firmware is available here:
http://h18023.www1.hp.com/support/files/storage/us/download/21200.html?jumpid=reg_R1002_USEN

# Replace SCSI ID 1, Drive ID 2. Predictive failures do not require further troubleshooting unless there has been recent firmware fixes.

Please note:
We have a predictive failure here.
So it is always better to replace the hard drive before the other hard drives fail which would result in a data loss.


Call HP for the replacement of the drive

Hope this answers!!!!

Regards,
rmn

Danijel Baloh
Occasional Contributor

Re: Proliant ML350G4 array diagnostic utility log help

Thank you for the prompt reply i have ordered the disk and will change it and update the firmware.

May the hw&sw gods be with thou! ;)
ramesh_naik_
Esteemed Contributor
Solution

Re: Proliant ML350G4 array diagnostic utility log help

Hi Danijel,

You may want to check this also:
http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Regards,
rmn
Danijel Baloh
Occasional Contributor

Re: Proliant ML350G4 array diagnostic utility log help

Ups did not notice that one :)