Proliant ML370 Server

[Asim Rana]

Hi All,

I have one ML 370 server. There are two processor in server of specs (P3 1 GHZ 133 MHz). One processor of server was faulty. I replaced the processor in warranty.
After installing new processor it showed error (212 Processor 1 failure).
When I check both processors in slot 1 separately it working properly. But when I install both processors at the same time this gives error. (212 Processor 1 failure).
Please advise me in above situation .
The operating System running on server is Windows Nt Server

Thank you

Asim Rana

[Robin_37]

Hi Asim
Install both the processor and Run the F10 system configuration utility and save the configuration

[Vijay_44]

Make sure the BIOS is updated as well, it may be that there is a big stepping difference between the two processors. While in the SCU clear your NVRAM and rerun the SCU.

[Tad Nall]

make sure you installed little power controller card so it can run second processor