HPE Community
ProLiant Servers (ML,DL,SL)
1752627 Members
5342 Online
108788 Solutions
New Discussion юеВ

Proliant PL1600 (500mhz P3 Dual Processor Model)

 
Richard_376
Occasional Contributor

тАО05-23-2005 01:08 AM

тАО05-23-2005 01:08 AM

Proliant PL1600 (500mhz P3 Dual Processor Model)

What is the highest processor this can go to and what would I need for example twin 866Mhz Twined pair of PIII's (866/256/1.65V S1 (SL47S) 133Mhz FSB)
0 Kudos
Reply
3 REPLIES 3
Vijay_44
Honored Contributor

тАО05-23-2005 01:13 AM

тАО05-23-2005 01:13 AM

Re: Proliant PL1600 (500mhz P3 Dual Processor Model)

The highest processor the PL1600 can take is a Pentium III 600MHz processors.
ThereтАЩs your problem!!! This thing is set to EVIL!
0 Kudos
Reply
Oleg Koroz
Honored Contributor

тАО05-23-2005 04:43 AM

тАО05-23-2005 04:43 AM

Re: Proliant PL1600 (500mhz P3 Dual Processor Model)

As addition if you willing to Upgrade to PIII 600, System I/O board need to be replaced to:

http://partsurfer.hp.com/cgi-bin/spi/showphoto?partnumber=155349-001
0 Kudos
Reply
Andrew Bauer
Occasional Advisor

тАО05-24-2005 12:12 AM

тАО05-24-2005 12:12 AM

Re: Proliant PL1600 (500mhz P3 Dual Processor Model)

I upgraded my PL1600R from a single PIII-500 to dual PIII-600's w/o replacing the I/O board (I didn't know I was supposed to). Everything works fine.

Anybody know what's different about the I/O board mentioned in the previous post?

Thanks,
Andy
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.