- Community Home
- >
- Servers and Operating Systems
- >
- ProLiant
- >
- ProLiant Servers (ML,DL,SL)
- >
- Proliant ml150 g3 raid not booting after rebuild
-
- Forums
-
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
- HPE Blog, Austria, Germany & Switzerland
- Blog HPE, France
- HPE Blog, Italy
- HPE Blog, Japan
- HPE Blog, Middle East
- HPE Blog, Russia
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
-
Blogs
- Advancing Life & Work
- Advantage EX
- Alliances
- Around the Storage Block
- HPE Blog, Latin America
- HPE Blog, Middle East
- HPE Blog, Saudi Arabia
- HPE Blog, South Africa
- HPE Blog, UK & Ireland
- HPE Ezmeral: Uncut
- OEM Solutions
- Servers & Systems: The Right Compute
- Tech Insights
- The Cloud Experience Everywhere
-
Information
- Community
- Welcome
- Getting Started
- FAQ
- Ranking Overview
- Rules of Participation
- Tips and Tricks
- Resources
- Announcements
- Email us
- Feedback
- Information Libraries
- Integrated Systems
- Networking
- Servers
- Storage
- Other HPE Sites
- Support Center
- Aruba Airheads Community
- Enterprise.nxt
- HPE Dev Community
- Cloud28+ Community
- Marketplace
-
Forums
-
Blogs
-
Information
-
English
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
08-21-2019 09:28 AM
08-21-2019 09:28 AM
Proliant ml150 g3 raid not booting after rebuild
hi, i have a ml150 g3 raid 1 with a disk failure, i've replaced the damaged disk with one of larger capacity hut same vendor (wd)
on boot i pressed f8 to access hp embedded raid utility so i can rebuild the array. the process end without any errors, but after reboot windows doesnt boot, only shows prompt. any clues?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
08-22-2019 09:59 PM
08-22-2019 09:59 PM
Re: Proliant ml150 g3 raid not booting after rebuild
Hi,
From the information shared if the status of the logical drive is healthy then it should boot up. First we always recommend our customers to keep a backup of the data whenever any activity is done post this you can check if the firmware mismatch is there between the drives. OS should boot up if the OS is installed in Raid 1 and one drive removed or fails so was it booting up before you replaced the drive with only 1 working drive in Raid 1. If yes then a deep analysis of the logs will be required and for that we recommend you to log a support ticket with us to have this checked at.
Regards,
Bunsol.
I am an HPE employee

Hewlett Packard Enterprise International
- Communities
- HPE Blogs and Forum
© Copyright 2021 Hewlett Packard Enterprise Development LP