ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Prolient 3000 SCSI error

Dino Apostolides
Occasional Visitor

Prolient 3000 SCSI error

When i powered the server on everythings seems to be fine, but then stops with the message that are no SCSI-Devices were found and display the Messages: "press F1" or "press F10".

If you press F1 server boots and works properly been thru the whole smartstart process, erased the settings using the disk etc, still cannot get this message to go away, once F1 is press server boots and works fine.

Any suggestions?

Thanks

Dino
2 REPLIES
chongkan
Trusted Contributor

Re: Prolient 3000 SCSI error

Are you using the Itegrated Dual Channel?

Clear NVRAM from RBSU or maintenance switch.

Dino Apostolides
Occasional Visitor

Re: Prolient 3000 SCSI error

I actually solved the problem by disabling the F1 error message the end of the post. All I cared obout was getting the machine to boot, as it runs properly after it boots I didn't care what was causing it to give the message.

Here is the link to the page that tells yu how to turn it off.

Thanks for at least trying to help.

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=115&prodSeriesId=254910&prodTypeId=15351&prodSeriesId=254910&objectID=c00182008