HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
ProLiant Servers (ML,DL,SL)
cancel
Showing results for 
Search instead for 
Did you mean: 

Q57 Netware drive and flowcontrol

 
SOLVED
Go to solution
Tony Wyland
Occasional Visitor

Q57 Netware drive and flowcontrol

Setting up a DL360 G4 with Netware 6.5 using the Q57.LAN driver. The driver loads and sets the flow control on the gigabit nic to none. I need to have to set to Rx and Tx. How do I get the nic to do flowcontrol? Command line parameter, nic utility, ....? BTW: The gigabit switch is set to enable flow control and an Intel NIC will automatically do it.

Tony Wyland
ITS - Messiah College
wyland@Messiah.edu

1 REPLY
HEM_2
Honored Contributor
Solution

Re: Q57 Netware drive and flowcontrol

Tony:

here are the load line parameters for flow control for the Q57.LAN:

TxFlow=
·This keyword allows enabling/disabling of TxFlow control.
· Choices are: ON, OFF
· Default is OFF

RxFlow=
·This keyword allows enabling/disabling of RxFlow control.
· Choices are: ON, OFF
· Default value is OFF


Hope this is what you were