QuickFind Diagnostic Display LEDs

[Pradip Chakrabarti]

Hi,

Can anyone share the QuickFind Diagnostic Display LEDs "Port 85 Codes" and their descriptions of DL580G3 Server

Thanks

[sandeep_raman]

Hello Pradip,

Is this what you are looking for?

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00432509/c00432509.pdf
Pg 64 of 104

CN:c00385409
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&objectID=c00385409&jumpid=reg_R1002_USEN#N1066E

SRH

[Pradip Chakrabarti]

Hi Sandeep,

Thanks, one more question

How to ensure that the port 84/85 switch is set to display port 85 codes?

Best Regards
Pradip

[sandeep_raman · Accepted solution]

Setting the switch to view port 85 codes

To change the display on the QuickFind diagnostic panel to view port 84 and 85 codes

("Troubleshooting the system using port 85 codes" on page 64):
1. Extend the server from the rack ("Extending the server from the rack" on page 15).
2. Remove the access panel ("Removing the access panel" on page 17).
3. Locate the switch on the media board ("System board components" on page 76).
4. Set the switch to the P85 position to view port 85 codes.

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00432509/c00432509.pdf
Pg 80 of 104

SRH

[Pradip Chakrabarti]

Thanks Sandeep

[Pradip Chakrabarti]

Found exact answer. Thanks again.

Pradip Chakrabarti